####   
     ##  
  #####  
 ##  ##  
  #####  
         

 _______ 
(  ____ \
| (    \/
| |      
| | ____ 
| | \_  )
| (___) |
(_______)
         

 _____ 
/  ___|
\ `--. 
 `--. \
/\__/ /
\____/ 
       
       

         
         
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
  #####  
         

 _____ 
(___  )
    | |
 _  | |
( )_| |
`\___/'
       
       

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Hallo I am from Denmark and I am planing to use a V3.2 on my VW Golf GTI 8V. MembersPage/HansK/IgnitionSetup MembersPage/HansK/EgoReadingProblems MembersPage/HansK/History ------------- 2005.06.19 Q.1) I have a bosch 2-pin idle-valve, but what settings should be used fore this, PWM, stepper? Does some one use the the same valve, and have a config-file that I can see? Q.2) If I start by using the original trigger-signal from the hall-sensor in the distributer (2 puls per rotation), what setup shuld I then use for the injectors? Can I get 4 "inj-output's" to "open" once per rotation? 2005.06.01 I got the new Megatune "mt-r014" and I tryed to use the firmware that was together whit it, but then I got no "output" on inj. or ign. and the the config and table was the same..? '''No problem..''' Just needed to chance secondary_trigger to "02" instead of "FF".
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.