##      
 ##      
 #####   
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
         

         
         
 ######  
  ##  ## 
  ##     
  ##     
 ####    
         

  ___  
 / _ \ 
/ /_\ \
|  _  |
| | | |
\_| |_/
       
       

         
         
  #####  
 #       
  ####   
      #  
 #####   
         

         
    ###  
   ##    
  #####  
   ##    
   ##    
   ##    
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
I'll install VEMS V3.3 in a AE86, first using factory harness by making an adaptor.. MembersPage/PhatBob - I'd advise you not to bother. The wire on all the AE86 harnesses I've seen are oxidized, the wires to the sensors on the distributor are not shielded so its almost impossible to get a clean trigger signal (We tried over a period of months to do this). And the injectors are batch wired. By the time you run new wires to the distributor, new wires and a resistor pack to the injectors, wires to the ignition coil, new ground wires from the VEMS to the injection manifold. You are only a few sensors away from a complete harness. Also the 4A-GE really comes alive with the Raw Engineering 36-1 trigger kit and wasted spark coils from the Mitsubishi Evo4, we have a large number of cars running this setup at the moment and doing well in competition http://vems.hu/www.vems.co.uk/forum/index.php?topic=3.0 http://img.photobucket.com/albums/v512/Sw33ps/Corolla/DSC00034.jpg '''Q.''' is it possible to drive all four injectors (They are 1 ohm each) with one or two inj-Fet's? And will it be possible to use serie resistor and transient suppressor diode then? http://www.vems.hu/files/HansK/AE86_Japan_ECUa_.jpg ---------------- http://www.vems.hu/wiki/index.php?page=VehicleFitment%2FToyota ----------------- MembersPage/HansK
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.