##  ##  
 ##  ##  
 ##  ##  
  ####   
   ##    
         

         
### ##   
 ### ##  
 ##  ##  
 ##  ##  
 ##  ##  
#### ### 
         

   ##    
         
  ###    
   ##    
   ##    
   ##    
 ######  
         

         
         
  ####   
 ##  ##  
 ##  ##  
 ##  ##  
  ####   
         

_________
\__   __/
   ) (   
   | |   
   | |   
   | |   
___) (___
\_______/
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
'''Flyback''' Q: What is the best flyback-solution for small low-Z injectors, 1,5-2,2Ohm ~150cc.. should I use inline resistors or chance diodes.. in this case I'm not interested in idle, I just need to get max posible power/speed from this little engine? A: Series resistors make it possible to use the transient suppressor diode mod for lowz injectors. To my suprise the series resistors themself improve the injector control significantly, but the real reason is to be able to use the transient suppressor mod. Even if the idle headroom increase significantly with these modification and large injectors I do it for an other reason. The VE table suddenly becomes almost entierly flat after the injector is properly controlled, this makes it very very easy to map the engine. With 150cc injectors the pulsewidths will be very long at all loads and the above modifications will not be as noticed as with 400-1600cc injectors. But I still recommend the series resistors and the transient suppressor diode mod as it will simplify the mapping procedure significantly. -Jörgen Karlsson Q: If I then use 6,8Ohm's resistors and a transient suppressor diode: * which diodes should I then use onboard (D76,89,109,179..)? Like fore High- or Low-Z? * what tolerance should the resistors have, 1%, 5%? ** not too important, injectors will work with 5 ohm or 7 ohm too *** okay but I was more thinking of, difference between the resistors, so the injectors get the same conditions. * How much effekt should they bee able to handle? 22 Watts enough? ** Make sure they handle 22 watts without proper mounting, its hard to mount them properly for cooling in the car.. I use 50W (20W without proper mounting) *** okay, I'll have to order some from RS. * I found this diode I already had: RM2535L Overvoltage Transient Suppressors. Datasheet says 24-32V and test says ~27V. Is that okay? what have you used? ** I have tried both 18V and 30V trans suppr diodes from webshop, both work properly, not sure about yours but it should work. //Emil// - thanks ------------ MembersPage/HansK
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.