_______ 
(  ___  )
| (   ) |
| (___) |
|  ___  |
| (   ) |
| )   ( |
|/     \|
         

 _   _ 
| | | |
| | | |
| | | |
\ \_/ /
 \___/ 
       
       

  _____  
 |  __ \ 
 | |__) |
 |  _  / 
 | | \ \ 
 |_|  \_\
         
         

    #    
         
   ##    
    #    
    #    
    #    
   ###   
         

         
   ##    
 ######  
   ##    
   ##    
   ##    
    ###  
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
The car is a Kadett C with a Calibra 2,0 16V C20XE engine mounted. ----------- 2006.09.13 The engine has a 60-2 trigger wheel on crank so I tryed to trigger the board with the signal-generator generating a 60-2 signal (m582 1740 200 20 1000 1000) but MT shows "trigger-errors", and a datalog shows random 0RPM one or two times every second. http://www.vems.hu/files/HansK/datalog200609122217_trigger_errors.xls I'm using firmware/MT 1.0.53 2006.09.19 I have tryed changing threshold on LM1815 with out luck. I'd like to try to use the board to generate the trigger-signal http://www.vems.hu/wiki/index.php?page=OutputTrigger but I '''need''' firmware V1.0.53 where '''MY_CONF += -D WOT_OUTPUT_TPS_THRESHOLD''' is enabled in the my_make file. Will some one with access to complete firmware please complile a firmware to me with this my_make file: http://www.vems.hu/files/HansK/my_make.zip Please upload it to my side www.vems.hu/files/HansK or just send it to me: kristiankh "a" ofir.dk --------------- Config: primary_trigger=01 #toothed wheel and VR sensor secondary_trigger=02 #disabled tooth_wheel=3A #58 teeth (60-2) trigger_tooth=10 #should it bee 02? explanation..? another_trigger_tooth=1E crank_minper=50 tooth_wheel_twidth1=6 tooth_wheel_twidth2=12 cam_sync_r_edge_phase=FF cam_sync_f_edge_phase=FF reset_engphase_after=FF #? ign_tdcdelay=9A ign_dwell14=3E ign_dwell6=60 ign_crank_advance=50 ign_out=70 ignchmax=01 # waste sparke ------------------ MembersPage/HansK
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.