_ _ ( ) ( ) | | | | | | | | | (_) | (_____)
## ### ## ## ####
____ | _ \ | |_) | | __/ |_|
_ | | | | | |___ |_____|
_______ ( ____ \ | ( \/ | (__ | __) | ( | ) |/
IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now. Visit Preferences to set your user name Summary of change: The car is a Kadett C with a Calibra 2,0 16V C20XE engine mounted. ----------- 2006.09.13 The engine has a 60-2 trigger wheel on crank so I tryed to trigger the board with the signal-generator generating a 60-2 signal (m582 1740 200 20 1000 1000) but MT shows "trigger-errors", and a datalog shows random 0RPM one or two times every second. http://www.vems.hu/files/HansK/datalog200609122217_trigger_errors.xls I'm using firmware/MT 1.0.53 2006.09.19 I have tryed changing threshold on LM1815 with out luck. I'd like to try useing the board to generate the trigger-signal but I '''need''' firmware V1.0.53 where '''MY_CONF += -D WOT_OUTPUT_TPS_THRESHOLD''' is enabled in the my-make file. my_make file, changed but not compiled: http://www.vems.hu/files/HansK/my_make.zip --------------- Config: primary_trigger=01 #toothed wheel and VR sensor secondary_trigger=02 #disabled tooth_wheel=3A #58 teeth (60-2) trigger_tooth=10 #should it bee 02? explanation..? another_trigger_tooth=1E crank_minper=50 tooth_wheel_twidth1=6 tooth_wheel_twidth2=12 cam_sync_r_edge_phase=FF cam_sync_f_edge_phase=FF reset_engphase_after=FF #? ign_tdcdelay=9A ign_dwell14=3E ign_dwell6=60 ign_crank_advance=50 ign_out=70 ignchmax=01 # waste sparke ------------------ MembersPage/HansK Optional: Add document to category: Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.