______ 
|  ___|
| |_   
|  _|  
| |    
\_|    
       
       

         
         
 ######  
  ##  ## 
  ##  ## 
  #####  
  ##     
 ####    

 ___   
(  _`\ 
| ( (_)
| |  _ 
| (_( )
(____/'
       
       

 ___   
(  _`\ 
| ( (_)
| |  _ 
| (_( )
(____/'
       
       

         
         
  #####  
 ##  ##  
 ##  ##  
  #####  
     ##  
 #####   

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Hello, I'm from Germany and have the Vems 3.xx PNP in an Audi S2 ABY. Unfortunately, I have a lot of problems with it and I hope the solution. With the original ECU the car is running without problems. When I Vems connected with the car, there is no ignition spark, and what I find so strange when you start in Mega Tune no RPM displayed wird.Also the pointer will not move! The pin's peiden from donors for ignition timing G4 were exchanged! Did perhaps someone such problems? Here is the Config files. http://www.vems.hu/files/AudiS2Turbo/mcd-saved.txt http://www.vems.hu/files/AudiS2Turbo/mct-saved.txt I hope the files help you to recognize the errors I now have the exhaust voltage test to the sparkplug for coil 1 When the ignition is on, it is 0.5 V. If I start it 1,2-1,3 V But that is still too little and can only lie at the Vems? ------------------------------------------------------------------ Hello, I do everything according to this guidance and with this the firmware there to invite. http://www.vems.hu/wiki/index.php?page=MembersPage%2FBrianWeldon Nevertheless, I have the same problem as vorher.Es is simply not! What can I still consider check? I test has been around for 2 weeks and I find nothing. How can man the trigger signals on a PC in view live? ------------------------------------------------------------------- Hi, Marc Swanson here. Did your ECU come with a hall inverter circuit installed? If so, you must make the following changes to your config: settings->primary trigger->trigger tooth = 0 (click burn to ecu) settings->ignition outputs: order should be from top to bottom: Stepper D 4 Stepper A Stepper B Stepper C after this, you should see RPM fluctuating while cranking...
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.