##  ##  
 ##  ##  
 ##  ##  
  #####  
    ##   
 ####    

   _____ 
  / ____|
 | |  __ 
 | | |_ |
 | |__| |
  \_____|
         
         

         
  ###    
   ##    
   ##    
   ##    
   ##    
  ####   
         

   ____  
  / __ \ 
 | |  | |
 | |  | |
 | |__| |
  \____/ 
         
         

         
         
  #####  
 ##  ##  
 ##  ##  
  #####  
     ##  
 #####   

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
I have the CAN BUS mockup module from the shop. https://shop.vems.hu/catalog/stm32f103mcp2515-p-213.html By what means can I change the CAN output Id's, scaling, offset etc? Is it pre-programmed into via firmware or is there any way of changing the config and then rebooting? I also received a USB stick which has 4 wires Yellow - SWDIO Brown - GND Orange - SWCLK RED - 3.3v Inside the module there is a 4 way header pin and also a micro USB connector. Can both be used, or just the 4 way header? ---------------------------- Testing step 1 I´m only getting Id 0x280 @ 500Kbit @ 10Hz but nothing on it. The ECU has RPM and is operating, but nothing is coming out on CAN at this ID. What configuration does it have? If nothing how can I put a config on it? I don´t have a Android phone to test the AIM out or a gauge but It looks like I´m not getting AIM out. Is AIM out only available via second RS232?
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.