_   __
| | / /
| |/ / 
|    \ 
| |\  \
\_| \_/
       
       

         
         
  #####  
 ##  ##  
 ##  ##  
  #####  
     ##  
 #####   

 _   _ 
| \ | |
|  \| |
| . ` |
| |\  |
\_| \_/
       
       

         
         
 #    #  
 #    #  
 #    #  
  #  #   
   ##    
         

     ##  
     ##  
  #####  
 ##  ##  
 ##  ##  
 ##  ##  
  #####  
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
''' Just some readings from a new Bosch Coolant Temp sensor (88 16v scirocco)''' ------ <code> degrees C kOhms -20 11.20 -10 10.00 9 3.36 20 2.42 30 1.72 40 1.16 60 0.72 69 0.63 74 0.59 </code> At 25C is appr. (2420 + 1720 ) *0.5 = 2070 Ohm, likely 2063 Ohm NTC. so depending on your AREF you'll need 2063_256 or 2063_287 see EasyTherm You asked on irc what NTC the default firwmare has. I checked. NTC's nominal value is the resistance at 25C. So I looked for the 25C point in the matfactor table of vems.hex: * internal value for 25C = 25 * 1.8 + 32 F = 25 * 1.8 + 32 + 40 = 117 = 0x75 * vems.hex mat table (0x200 .. 0x2F0) 0x75 can be found at :100280007A79797877777676'''75'''747473727271701B ** 0x88 position whats in firmware at :100280007A79797877777676'''75'''747473727271701B Since the NTC makes a voltage divider with a 2700 Ohm (onboard) resistor, at 25C the NTC resistance is (proportional to) 0x88 when the 2700 Ohm is (proportional to) 256-0x87=0x78 This reads: 2700/0x78 * 0x88 = 3060 Ohm nominal value You likely want to hexpatch your firmware for an NTC of lower nominal value (closer to your 2063 Ohm NTC). It takes 2 mins to download/unzip and 2 mins to parameter hexpatch.exe and 2 mins to upload new firmware. See EasyTherm
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.