##   
         
    ##   
    ##   
    ##   
    ##   
 ####    

         
         
  ####   
     ##  
  #####  
 ##  ##  
  #####  
         

         
         
 ##   ## 
 ## # ## 
 ####### 
  #####  
  ## ##  
         

   _____ 
  / ____|
 | |  __ 
 | | |_ |
 | |__| |
  \_____|
         
         

         
         
 #####   
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
'''Please add your coments for my first VEMS project.''' There is inconvenient to find rigt thread for newbie... :( For first want to put VEMS on BMW M50 modified engine with COPs for dragrace. It is 6cyl 24V DOHC engine bored up to 3L. Deeply rebuilded head, very agresive cams for this stroke. Custom make intake system with large reciever. And more. '''Why I want to put VEMS because:''' 1) COP (general) 2)WBO2 on board 3)sequential injection '''What features I can't find:''' 1) Launch control! 2) traction control for beter acceleration control in first 2 gears(rough like MSNS-E have) 3) ignition retard due hot intake and advance for cold engine 4) two engine maps ('street fuel/race' fuel alike) and more '''My shopping cart looks so:''' 1 x VEMS sticker 1 x Alubos EC frontplate 2 x Alubos gasket 1 x Alubos Endplate 1 x Alubos1600 1 x Additional VR or Coil interface (both sensors is VR) 1 x Dual channel knock sensor interface (just for experiment) 1 x EGT input amplifier (just for experiment) 1 x Econoseal18-PCB 1 x Econoseal18-Wire 1 x Econoseal36-PCB 1 x EconoSeal36-Wire 7 x Ignition driver 8 x Injector or WBO2 heater driver (how much FETs need one injector chanel???) 1 x Wideband O2 sensor 1 x Ignition driver insulator sheet 1 x LCD4x20 1 x Wideband connector 1 x Genboard v3.3 May be better is to put Genboard PCB inside Motronic ECU?
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.