_  __
 | |/ /
 | ' / 
 |  <  
 | . \ 
 |_|\_\
       
       

         
         
 ##   ## 
 ## # ## 
 ####### 
  #####  
  ## ##  
         

   #     
   #     
 #####   
   #     
   #     
   #  #  
    ##   
         

         
         
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
  #####  
         

         
         
 # ###   
 ##   #  
 #       
 #       
 #       
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
There are two coolant temp sensors in thermostat housing. I had measured them at room temp. '120' ohm sensor (only one pin connected in sensor end connector) is for instrument cluster water temp gauge. '2.18' kohm sensor is for engine ecu. This one shows 120ohms at 25 celsius: http://quasar.dynaweb.hu/~lezsi/bmw/original/PICT0023-coolant-sens-120ohm-at-25c.JPG And this is 2.18 kohms at 25c http://quasar.dynaweb.hu/~lezsi/bmw/original/PICT0024-coolant-sens-2_18kohm-at-25c.JPG
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.