#####  
 ##      
  ####   
     ##  
 #####   
         

         
     ##  
     ##  
  #####  
 ##  ##  
 ##  ##  
  #####  
         

 _______ 
(  ____ )
| (    )|
| (____)|
|  _____)
| (      
| )      
|/       
         

         
         
  ####   
     ##  
  #####  
 ##  ##  
  #####  
         

 __   __
 \ \ / /
  \ V / 
   | |  
   |_|  
        

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
'''Stage 0''' I thought I do the smallest first step possible: Install a genboard to get sensor data only. First time (this stage) I want to see that all the necessary input data is OK. ---- '''These are now obsolete! I realised that it's really hard to split every signal for two computers (both mechanically and electrically). Now I skip this stage and go directly to Stage 1''' In fact car was running about 5 mins in this stage before started in stage 1 :) ---- Watched data are: *VR signal -RPM (need to share with motronic) *MAP (sensor installation needed) - motronic doesn't use it *IAT (sensor installation needed) - motronic has separate at AFM *CLT (could be shared with motronic, otherwise motronic will work even worse either at cold-startup or warmed engine) - worked roughly. *WBO2 (sensor installation needed) - motronic doesn't use it *TPS -simply replaced old switch. Motronic lives without it *cam signal from ign wire - didn't connected to genboard If I can successfully get/share those signals, I can watch original working parameters and ready to go to stage 1.
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.