____ | _ \ | |_) | | _ < | |_) | |____/
# ### ## # ## # # ### # #
#### # # # # # ####
##### ## ## ## ## ## ## ## ##
### ## ### ## ## ## ## ## ### ## ## ## ###
IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now. Visit Preferences to set your user name Summary of change: ''' Stage 2 - control ignition besides fuel ''' News - 2005.07.13 After all the car is running without motronic. GOAL! :) /It's still in place however/ Finally inj and ign is fine. Had some difficulties with trigger, first we suspected signal-sharing problems with motronic (series cond) but later realized that a resistor was absent in factory v3.3. This caused trigger errors in higher rpm range and was depending on heat or something related to running time. After correcting that, engine was running fine. '''Q - Which resistor was it? And which type of trigger are you using?''' Still has some knock (by ear), but ignition map is a freehand sketch yet. Waiting for dyno now. ---- Next attempt I'm going to control ignition too. -There's hardly any advantage of staying with motronic. GenBoard is ready for drive my ignition. Factory coil and mechanical distributor is OK for the first time. When it's possible I'm going to wasted spark packs. (There's no room for COP) I need to know 60-2 wheel's trigger position relative to TDC. Moved this section to MembersPage/GergelyLezsak/Trigger ---- Some additional tasks: * Control Idle solenoid - MembersPage/GergelyLezsak/IdleControl * Control tachometer * Wire-in fuel-pump relay * Control fuel consumption gauge (?) * Boost control solenoid ---- '''Suggestions...''' (or by phone# 1-2209238 in the evening) Optional: Add document to category: Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.