##  ##  
  ####   
   ##    
  ####   
 ##  ##  
         

         
   ##    
         
  ###    
   ##    
   ##    
  ####   
         

         
  ####   
 ##  ##  
 ######  
 ##      
 ##      
  ####   
         

 ______
|___  /
   / / 
  / /  
./ /___
\_____/
       
       

   ##    
         
  ###    
   ##    
   ##    
   ##    
 ######  
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
= Mitsubishi 6G72 page = Installing VEMS into a '''Mitsubishi Galant 2.5 V6 turbo''', engine code '''6G72''' (Cyclone V6 engine firing order: ...) Timing info on MembersPage/PeterJensenMitsubishi '''Apparently supported by any nonancient fw''' (use >=1.2.31 for other reasons) with proper config. Trigger pattern is a bit unusual. Trigger wheel is like this: http://www.vems.hu/files/MembersPage/PeterJensen/mitsu/trigger.JPG It's very similar to the Lancer EVO trigger, but 6 cyls instead of 4. MembersPage/Fero/MitsubishiEVO Apparently Peter Jensen had experience with this engine back in 2010, but now I cannot open his old triggerlogs, or interpret those configs with currently accesible VemsTune versions: http://www.vems.hu/files/MembersPage/PeterJensen/mitsu/ ---- '''Some hints to prepare?''' '''Scope and/or Bench-test''' with the following in mind: * start from VT primtrig dialog bottom, EVO configlet, key (verify after setting) is ** primtrig normal coil with sectrig subaruspecial = EVO 6-7-8 ** bit6 of: config_secondary_trigger & _BV(strig_subaruspecial) ... * sync condition: '''sectrig (falling) to primtrig (rising) time < 80/180 * period''' ** threshold is 80 deg for 4 cyl (where period is 180 crankdeg) ** threshold is '''53 deg for 6cyl''' (where period is 120 crankdeg). Is that good or not for this 6 cyl trigger ? *** on this V6 : 45 degrees in 3 occasions (=> exact same condition not good for V6). *** however, '''sectrig falling to primtrig falling < 53 deg''' is true for one event (25 deg from 100 to 75 ; please confirm !) '''=> so no firmware mod needed apparently, just configure "EVO" and than change to 6cyl and primtrig falling''' Note: Marcell didn't notice that primtrig falling needed in this case, and implemented a CYCLONEV6 fw mod (in effect when "EVO" with >4 cyl configured; 1.2.36 version, but not published): at primtrig (falling), NO sectrig (falling) pulse seen since last primtrig ** but looking at the pulsetrain again, it seems now that happens twice (than NOT good) Proceed path: get '''scopeshot(s) or angular positions numerically''' (or verify Peter's) * can be captured with VEMS configured to simple coiltype trigger + strobe if you know what you're doing ** but better scope, or get a free USB soundcard from Marcell and fry that (NOT your notebook's mic input :-). Mix the primtrig and sectrig with DIFFERENT resistors (because most USB soundcards have only 1 channel input; only output is stereo). ** timing is everything here: precise info needed to make a good "signalgen" wav for audacity benchtesting (results are not valid if sectrig relative pos is different than real)
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.