###      
 #####   
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
######   
         

 ___   
(  _`\ 
| |_) )
| ,__/'
| |    
(_)    
       
       

 _____ 
|  __ \
| |  \/
| | __ 
| |_\ \
 \____/
       
       

 _____ 
|  __ \
| |  \/
| | __ 
| |_\ \
 \____/
       
       

 _______ 
(  ____ \
| (    \/
| (__    
|  __)   
| (      
| )      
|/       
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
'''Other Docs found''' Found some info in haltech docs: BAC Hi BAC high is a form of BAC idle control that is used for 3-wire BAC valves with two coils. These valves are sprung so that when no coils are energised, the BAC valve sits at 50% open. Two PWM signals are used to move the coils. One signal moves the valve from 0% to 50% open, while the other signal moves the valve from 50% to 100% open. The BAC Hi output moves the valve from 50% to 100%. When the target position for the valve is between 50% and 100%, this output will provide a signal from 0% to 100% duty. All idle control tuning and setup is done with the BAC Hi output. Refer to section 3.13 for details on how to tune your idle control. BAC Low The BAC low output is used to control the BAC valve when the target opening is 0% to 50% open. When the valve target position is 0%, the output duty is 100%. When the target is 50% open, the output duty is zero to allow the spring to return the valve to its default position. BAC Inverted '''For 3-wire BAC valves that do not have a spring''' to return the valve to the centre position, use BAC and BAC Inverted to control the valve. Connect the BAC output to the coil that pulls the BAC valve open. Connect the BAC Inverted output to the coil that pulls the BAC valve closed. The BAC Inverted signal is a complementary signal to the BAC signal. If the BAC output is set to 70% duty, then the BAC Inverted signal is set to 30% duty. All idle control tuning and setup is done with the BAC output. pwm freq maybe in 200-1000hz range? [http://www.haltech.com.au/downloads/E11_Instruction_Manual_12.pdf original doc]
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.