_______ 
(       )
| () () |
| || || |
| |(_)| |
| |   | |
| )   ( |
|/     \|
         

         
   ##    
         
  ###    
   ##    
   ##    
  ####   
         

         
         
  ####   
 ##  ##  
 ##  ##  
 ##  ##  
  ####   
         

         
         
 ##  ##  
 ##  ##  
 ##  ##  
  ####   
   ##    
         

 _______ 
(  ____ \
| (    \/
| (__    
|  __)   
| (      
| (____/\
(_______/
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
'''Coil Over Ignition page''' I plan to use COPs from the new BMW engines: http://quasar.dynaweb.hu/~lezsi/bmw/e90-cop2.jpg These are from a new 3-series car (E90) I measured * ~1 ohm resistance between the two bottom pins * direct contact (0 Ohm) between the third pin and the outer core of (unshielded part of) the tube. * However HV plug-connection doesn't seem to connect to anything ** maybe 10..20 kOhm towards the shield pin ? If you can measure this, the transformer is likely OK Question: * Where can I find such special connectors? * How much dwell might be necessary? ** probably short, start with 1 .. 1.5 msec well, measure supply current (at known RPM) so we know
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.