######  
  ##  ## 
  ##     
  ##     
 ####    
         

 __      __
 \ \    / /
  \ \  / / 
   \ \/ /  
    \  /   
     \/    
           
           

   _____ 
  / ____|
 | |     
 | |     
 | |____ 
  \_____|
         
         

         
         
  #####  
 ##      
  ####   
     ##  
 #####   
         

         
         
 ##  ##  
  ####   
   ##    
  ####   
 ##  ##  
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
'''Coil Over Ignition page''' I plan to use COPs from the new BMW engines: http://quasar.dynaweb.hu/~lezsi/bmw/e90-cop2.jpg These are from a new 3-series car (E90) I measured ~1 ohms resistance between the two bottom pins, and direct contact (no resistance) between the third pin and the outer core of (unshielded part of) the tube. However I can't measure any resistance at the plug-connection. Question: *Does it seem OK? How to test it? *Where can I find such special connectors? *How much dwell might be necessary?
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.