_____ 
|  _  |
| | | |
| | | |
\ \/' /
 \_/\_\
       
       

         
         
  ###### 
 ##  ##  
 ##  ##  
  #####  
     ##  
    #### 

 ##      
 ##      
 ##  ##  
 ## ##   
 ####    
 ## ##   
 ##  ##  
         

         
         
 #####   
 ##  ##  
 ##      
 ##      
 ##      
         

 _       
| \    /\
|  \  / /
|  (_/ / 
|   _ (  
|  ( \ \ 
|  /  \ \
|_/    \/
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
'''Coil Over Ignition page''' I plan to use COPs from the new BMW engines: http://quasar.dynaweb.hu/~lezsi/bmw/e90-cop2.jpg These are from a new 3-series car (E90) I measured ~1 ohms resistance between the two bottom pins, and direct contact (no resistance) between the third pin and the outer core of (unshielded part of) the tube. However I can't measure any resistance at the plug-connection. Question: *Does it seem OK? *And how much dwell might be necessary?
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.