_____ 
 | ____|
 |  _|  
 | |___ 
 |_____|
        

    ##   
         
    ##   
    ##   
    ##   
    ##   
    ##   
  ###    

         
### ##   
 ### ##  
 ##  ##  
 ##  ##  
 ##  ##  
#### ### 
         

 _       
| \    /\
|  \  / /
|  (_/ / 
|   _ (  
|  ( \ \ 
|  /  \ \
|_/    \/
         

 ______
|___  /
   / / 
  / /  
./ /___
\_____/
       
       

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
'''GenBoard/VerThree install on Honda B16A2 engine''' * initially naturally aspirated, but later for turbo version ---- '''Trigger''' There are 3 transmitters with toothcount 1,4,24 in the distributor (with honda PGM-FI ECM pin numbers): * 1 (B11 ?) Autodata lists 0.2V for cranking, 0.7V at idle and 2.5V at 3000 RPM for B11 * 4 (B13 ?) Autodata lists 0.4V for cranking, 1.5V at idle and 5V at 3000 RPM for B13 * B12 Autodata lists 0V for cranking, idle and 3000 RPM (this must be ground line) * B14 Autodata lists 0V for cranking, idle and 3000 RPM (this must be ground line) As you see, autodata suggests that these are VR signals (amplitude increases with RPM). If above is true (2 VR signals), the assembled ECM auditrigger configuration should be used without the cam-HALL connected. Any confirmation would be welcome.
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.