#       
 #       
 # ###   
 ##   #  
 #    #  
 #    #  
 #    #  
         

         
         
  #####  
 #       
  ####   
      #  
 #####   
         

    ###  
     ##  
     ##  
  #####  
 ##  ##  
 ##  ##  
  ###### 
         

_________
\__   __/
   ) (   
   | |   
   | |   
   | |   
___) (___
\_______/
         

         
         
  ####   
 ##      
 ##      
 ##      
  ####   
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Hi, I've assembled the PCB and upgraded the firmware. All was well with only a 1 amp fuse needed in the power feed to pin 25. I then fitted it to the case and clamped down the FETs and IGBTs. The Insulating sheet was already fitted to the case when it arrived. It blew the fuse in the feed to pin 25 as soon as I powered it up:( I removed it from the case and the PCB is still drawing 2.5 amps. I've not connected any coils, injectors or sensors to the ECU, just the power to pin 25, the 5 grounds and the RS232 If anyone can suggest what to check..... Thanks :) *Try to connect only + to pin 25 and Gnd to pin 26 then you should be able to connect with megatune. If the fuse blows then there is another problem Normally you only need four Gnd i.e. pin 5, 21, and 32 is Power Gnd´s and pin 26 is the processor Gnd. See this diagram http://www.vems.hu/wiki/index.php?page=MembersPage%2FPeterJensenwiring Thanks, sorted this today,main diode had gone down. Wish that FET / IGBT picture was in the build manual! [[! MembersPage/GavinBat]]
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.