##  
     ##  
  #####  
 ##  ##  
 ##  ##  
  #####  
         

         
         
 ##  ##  
  ####   
   ##    
  ####   
 ##  ##  
         

 _______ 
(_____  )
     /'/'
   /'/'  
 /'/'___ 
(_______)
         
         

         
         
  #####  
 ##      
  ####   
     ##  
 #####   
         

         
         
  ####   
 ##      
 ##      
 ##      
  ####   
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Mitsubishi Evo 6 Computer sn: 5030 Trigger: Primary: Coil type hall sensor (original) Secondary: hall sensor (original) Ignition: Wasted Spark 1&4 and 2&3 Other sensors: IAT, CLT, TPS, 400kPa MAP sensor, WBO2 sensor, EGT sensor Fuel: Ethanol Could you help me in the these issues: Configuration of the primary and the secondary triggers. I'm not sure how to configure the secondary trigger. * use "Mitsubishi_Evo_6-7-8" configlet at the bottom of primary trigger (it also effects secondary trigger). Burn and reboot ECU. ** in case of any issue, also capture (and publish) triggerlog so we can see that both trigger connections are functional. I attached the current configuration, which we use in the car, the trigger log, and the original figure from the secondary trigger I found in the manual. I uploaded the files to FileArea/GaborJuhasz ---- '''idle stepper motor''' unipolar, 6 pins. I added some diodes and it works. The problem is, if i set the "power off steppers after steps" on, the outputs set to grounds, and the current flow through every coil. * '''why not connect the common pin to GND, not to +12V ?''' ** We dont wanted to modify the default cable harness. If it wouldnt possible to modify it via the firmware, than we have connected the common PIN to GND. * Is this possible, to modify the firmware like this: '''if the "iac stepper polarity = negative"''' (active pin set to ground, inactive pins set to high) '''then the "power off steppers after steps" set to outputs high?''' ** good idea ! Yes, it is possible. Done in 1.1.98 *** When can we download the new 1.1.98 firmware? I dont know, that the stepper motor sequence in the program belongs to the opening, or the closing direction. * '''opening''' (iac_pos ++). But noone really thinks about direction when installing: just reverses when necessary. The car is running with ethanol, and I should set lambda to 0.65-0.7, but the program starts from 0.7. Could it be modified to start from 0.6? And again, could it be possible, to modify the VEMSTUNE to set the minimum lambda to 0.6?
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.