##   
   #  #  
   #     
 #####   
   #     
   #     
   #     
         

         
|\     /|
( \   / )
 \ (_) / 
  \   /  
   ) (   
   | |   
   \_/   
         

         
         
 #####   
 ##  ##  
 ##  ##  
 #####   
 ##      
 ##      

  ______
 |___  /
    / / 
   / /  
  / /__ 
 /_____|
        
        

         
  #####  
 ##  ##  
 ##      
 ##      
 ##   #  
  ####   
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Mitsubishi Evo 6 Computer sn: 5030 Trigger: Primary: Coil type hall sensor (original) Secondary: hall sensor (original) Ignition: Wasted Spark 1&4 and 2&3 Other sensors: IAT, CLT, TPS, 400kPa MAP sensor, WBO2 sensor, EGT sensor Fuel: Ethanol Could you help me in the these issues: Configuration of the primary and the secondary triggers. I'm not sure how to configure the secondary trigger. * use "Mitsubishi_Evo_6-7-8" configlet at the bottom of primary trigger (it also effects secondary trigger). Burn and reboot ECU. ** in case of any issue, also capture (and publish) triggerlog so we can see that both trigger connections are functional. I attached the current configuration, which we use in the car, the trigger log, and the original figure from the secondary trigger I found in the manual. I uploaded the files to FileArea/GaborJuhasz ---- '''idle stepper motor''' unipolar, 6 pins. I added some diodes and it works. The problem is, if i set the "power off steppers after steps" on, the outputs set to grounds, and the current flow through every coil. * '''why not connect the common pin to GND, not to +12V ?''' * Is this possible, to modify the firmware like this: '''if the "iac stepper polarity = negative"''' (active pin set to ground, inactive pins set to high) '''then the "power off steppers after steps" set to outputs high?''' ** good idea ! Yes, it is possible. Done in 1.1.98 I dont know, that the stepper motor sequence in the program belongs to the opening, or the closing direction. * '''opening''' (iac_pos ++). But noone really thinks about direction when installing: just reverses when necessary. The car is running with ethanol, and I should set lambda to 0.65-0.7, but the program starts from 0.7. Could it be modified to start from 0.6?
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.