####   
     ##  
  #####  
 ##  ##  
  #####  
         

__   __
\ \ / /
 \ V / 
  \ /  
  | |  
  \_/  
       
       

  _____ 
 |_   _|
   | |  
   | |  
  _| |_ 
 |_____|
        
        

  _____  
 |  __ \ 
 | |  | |
 | |  | |
 | |__| |
 |_____/ 
         
         

         
   ##    
         
  ###    
   ##    
   ##    
  ####   
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
I'm trying to connect HALL to both primary and secondary inputs on my development board. http://www.vems.hu/files/FredrikJagenheim/hall30.jpg '''Trigger1:''' Pin is connected to IC by 10k R55 and shorted SJ2. It's protected by a 5.1V zener on D14 and a short on D13. It's pulled up by a 10k R88 and shorted SJ6. '''Trigger2:''' Pin is connected to IC by 10k R91 and shorted SJ5. It's protected by a 5.1V zener on D27 and short on D24. It's pulled up by a 10k R59 and a short on SJ7. '''The result''' The board boots, but doesn't run lcd_update. Stuck in primary/secondary trigger handler? This happen even if I disconnect the trigger pins; so I guess I've botched the pull-up.
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.