_     
| |    
| |    
| |    
| |____
\_____/
       
       

         
         
 ##  ##  
 ##  ##  
 ##  ##  
  ####   
   ##    
         

  _____ 
 | ____|
 |  _|  
 | |___ 
 |_____|
        

  _   _ 
 | | | |
 | |_| |
 |  _  |
 |_| |_|
        

 ___   
(  _`\ 
| (_) )
|  _ <'
| (_) )
(____/'
       
       

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
I'm trying to connect HALL to both primary and secondary inputs on my development board. This is what I've figured out: http://jagenheim.se/hall-3.0.jpg The red areas are +5V, probably good to use as pullups. Trigger 1 is the magenta area; it needs a resistor (not pictured) at the voltage regulator to get there. It should connect to the cyan area, which is the input pin on the atmega. Trigger 2 is the Yellow area; it should connect to the Blue area. Does anyone have a good idea on how to make all these connected? *trigg2= R91 stuffed, D24 should be a short, and D27 a 5.1V, zeener SJ5 shorted *trigg1=R55 stuffed, D13 short, D14=5.1V zeener, SJ2 solderd http://www.vems.hu/files/MembersPage/FredrikJagenheim/hall-3.0.jpg
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.