#    #  
  #  #   
   ##    
  #  #   
 #    #  
         

         
  ###    
   ##    
   ##    
   ##    
   ##    
  ####   
         

  _____  
 |  __ \ 
 | |__) |
 |  ___/ 
 | |     
 |_|     
         
         

         
         
 ##  ##  
 ##  ##  
 ##  ##  
  #####  
     ##  
 #####   

         
         
  #####  
 #       
  ####   
      #  
 #####   
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
I'm trying to connect HALL to both primary and secondary inputs on my development board. This is what I've figured out: http://jagenheim.se/hall-3.0.jpg The red areas are +5V, probably good to use as pullups. Trigger 1 is the magenta area; it needs a resistor (not pictured) at the voltage regulator to get there. It should connect to the cyan area, which is the input pin on the atmega. Trigger 2 is the Yellow area; it should connect to the Blue area. Does anyone have a good idea on how to make all these connected? *trigg2= R91 stuffed D24 should be a short and D27 a 5.1V zeener SJ5 shorted *trigg1=R55 stuffed D13 short D14=5.1V zeener SJ2 solderd
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.