##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
  #####  
         

         
  ####   
     ##  
  #####  
 ##  ##  
 ##  ##  
  ### ## 
         

 #       
 #       
 # ###   
 ##   #  
 #    #  
 ##   #  
 # ###   
         

         
         
 ##  ##  
 ##  ##  
 ##  ##  
  ####   
   ##    
         

   ###   
  ## ##  
  ##     
 ####    
  ##     
  ##     
 ####    
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
'''Trigger output''' For testing the trigger output I've soldered a 1k resistor from the output at the IGN_259 and a LED over the output to GND. http://www.vems.hu/files/FredrikJagenheim/trigger.jpg ---- '''HALL:''' (done) '''Trigger1:''' Pin is connected to IC by 10k R55 and shorted SJ2. It's protected by a 5.1V zener on D14 and a short on D13. '''Trigger2:''' Pin is connected to IC by 10k R91 and shorted SJ5. It's protected by a 5.1V zener on D27 and short on D24. The signal should look like this 'hall signal -> pulled up by 10k to 5v -> 10k series resistor -> 5v1 zener to ground -> ic1 pin'. Thanks, Dave. '''Schematic diagram showing the recommended hall setup''' [http://www.vems.hu/files/DaveBrul/mini_hall.JPG hall schematic diagram]
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.