_____ 
(_   _)
  | |  
  | |  
  | |  
  (_)  
       
       

         
         
  ####   
 #    #  
 ######  
 #       
  ####   
         

         
### #### 
 ##  ##  
 ##  ##  
 ##  ##  
 ######  
     ##  
 #####   

   ___  
  / _ \ 
 | | | |
 | |_| |
  \__\_\
        

  ###    
   ##    
   ##    
   ##    
   ##    
   ##    
  ####   
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
'''Mitsubishi EVO VI-VIII''' *4 cyl, 2.0 4G63 engine *Vems V3.3 *wastedsapark active coil *turbocharged *stepper IAC valve *4 bar MAP sensor *HALL crank sensor *HALL cam sensor My plan is to use the stock trigger system. It is important because the race rules don't allow to modify it and mitsubishi EVO-s are more than 90 percent of the racecars here. It's a very big market. Here is the stock crank triggerwheel. It has two simple big 67 deg tooth, The rising edge of the tooth is 67-70 deg before TDC: http://www.vems.hu/files/Fero/mitsubishiEVO/crank1.jpg http://www.vems.hu/files/Fero/mitsubishiEVO/crank2.jpg ------ And here is the cam trigger. The proble is here. There are a bigger and a smaller tooth on it, i don't know the exact TDC position yet: http://www.vems.hu/files/Fero/mitsubishiEVO/cam.jpg My question that is it possible to use this trigger system with vems? Or maybe make some little board to modify the cam trigger signel to be seems only one tooth? Because on that way it could be a simple 4+1 trigger system.
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.