##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
  #####  
         

         
         
 #####   
 ##  ##  
 ##  ##  
 #####   
 ##      
 ##      

         
         
  ####   
 #    #  
 #       
 #    #  
  ####   
         

 _______ 
(  ____ \
| (    \/
| (__    
|  __)   
| (      
| )      
|/       
         

         
         
 # ###   
 ##   #  
 ##   #  
 # ###   
 #       
 #       

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
'''LANCIA DELTA INTEGRALE HF 16V''' rallycross cars. *2L engine *4 Cyl *turbo *12-1 toothweel with HALL trigger ** no camsync *wasted spark coil *4 bar MAP sensor, about 1.7 - 1.8 bar boost *permanently opened throttle body for ALS There are 2 cars here, they are almost the same, except one of them has high impedance injectors, and the other have low impedance injectors. The cars was running succesfully from a year with VEMS, and with 1.0.38 firmware, everything was OK. They use start limiter and boost control too. Now the cars came back. They need ALS. --------- '''News:''' The car works good with this 12-1 HALL triggerwheel and 1.1.14 firmware. But ALS needs some more clarification. http://www.vems.hu/files/Fero/Lancia/HALL_LAncia.jpg ----- '''ALS''' ** using 1.1.14 firmware now ** throttle is always open, the TPS shows 36% at idle. ** using the gasoline-eater soft idle ignition cut for idle. '''config dump:''' * http://www.vems.hu/files/Fero/Lancia/new/config.txt * http://www.vems.hu/files/Fero/Lancia/new/tables.txt * [http://www.vems.hu/files/Fero/Lancia/datalog200702241148.xls a short log] '''The ALS works almost perfectly,but there are some errors!''' * If i set the ALS deactivation time to 0 (zero), than everything is OK, It idles,when i push the TPS it turnes into ALS mode,but stayes in ALS mode forever. But if i set the deactivation time to 6 seconds or anything else, than it seems, that the ECU does not turn on the ALS funcion, or maybe turnes it on only for a very short time. * If ALS switch is turned ON, than the EGO control is always OFF. But the EGO correction should be OFF only when the ALS '''function''' is active, not the switch.
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.