##  
         
    ###  
     ##  
     ##  
 ##  ##  
 ##  ##  
  ####   

  __  __ 
 |  \/  |
 | |\/| |
 | |  | |
 |_|  |_|
         

  ______
 |___  /
    / / 
   / /  
  / /__ 
 /_____|
        
        

         
         
  ####   
 ##  ##  
 ##      
 ##  ##  
  ####   
         

         
         
  ####   
 ##  ##  
 ######  
 ##      
  #####  
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Here i write my firmware wishes, theese are needed for my projects. - Dual WBO. * http://cell.dyndns.ws/f/ v3_... 1.1.99 (2012-03-25 or newer) * VT 2012-03-27 or newer, or unzip [http://cell.dyndns.ws/f/VTconfig1.1.99.zip VTconfig1.1.99.zip] in existing VT * connect 2nd WBO2 sensor into 1st connector, do the calibration, remember result. Write result into wbo2 calibration sensor 2" (was ri_target"), then burn * connect WBO2 SENSOR 1 into plug 1 and calibrate as usually. - I need fuel conpsumtion(l/h) to be displayed in LCD. I suggest to delete the useless page3 and make a new page instead of it with the following data to be displayed: RPM,MAP,LA,TPS,CLT,IAT,BATTERY VOLTAGE,FUEL CONSUMPTION. Or the best option would be to make theese 8 data to be choosable in vemstune for a suitable LCD page. - Periodically(about 30secs) LCD reinitalize should be a choosable option. Because resonance often cause problems on racecars with LCDs. -Antilag and launchcontrol cause problems with newer firmwares. If i use both of them, than the car stays in launch mode, instead of antilag mode. This is a serious error. I uploaded an issue report with configs and logs to check this situation. -AIM dashboard does not working with newer firmware, ir freezes at boot. The dashboards were working good with the older 1.1.74 firmware version. So the communication must be repaired, or to be choosable the old method.
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.