#####  
 ##  ##  
 ##  ##  
  #####  
     ##  
     ##  

         
         
  ### ## 
 ##  ##  
 ##  ##  
  #####  
     ##  
 #####   

       _ 
      | |
      | |
  _   | |
 | |__| |
  \____/ 
         
         

 #       
 #       
 # ###   
 ##   #  
 #    #  
 #    #  
 #    #  
         

         
         
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
  #####  
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
This project is a BMW 318 race car. *'''VEMS V3.3''' with firmware 1.0.38 *1.8 '''NA''' 4 cyl Engine. *'''4 injectors''' and '''4 COP coils'''. *'''60-2''' trigger wheel on the crank with VR. *'''1 tooth''' trigger on tha CAM with VR. *Using '''CAMSYNC'''. --------- The cableworks are done, everything is OK. At first I've tested the crank trigger. I turned off the secondary trigger and push the engine starter. Everything works OK. The RPM is rock stable, no trigger errors at all! Than i've turned on the CAM trigger too, but the RPM is not OK, sometimes it raises to 65500 then falls back. I've tried to change the polarity of the trigger2, didn't helped that. What could be the problem? Here are the config files: [http://www.vems.hu/files/MembersPage/Fero/BMW%20zalan/config.txt config.txt] [http://www.vems.hu/files/MembersPage/Fero/BMW%20zalan/tables.txt tables.txt] And here is the trigger log i've made: [http://www.vems.hu/files/MembersPage/Fero/BMW%20zalan/BMWtrigger.log Triggerlog] The CRANK trigger is absolutely no problem, you can see the angle settings in the config. I've checked,and it works perfect. But here is a picture about the CAM trigger when the engine is TDC at the first cylinder. The tooth is slightly after the 3rd cyl workphase. http://www.vems.hu/files/MembersPage/Fero/BMW%20zalan/camtrigger.jpg Please check the config and log i've made. What could be the problem?
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.