### 
  #####  
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
  ### ## 
         

           
     /\    
    /  \   
   / /\ \  
  / ____ \ 
 /_/    \_\
           
           

         
         
 ######  
    ##   
   ##    
  ##     
 ######  
         

    ###  
     ##  
     ##  
  #####  
 ##  ##  
 ##  ##  
  ###### 
         

__   __
\ \ / /
 \ V / 
  \ /  
  | |  
  \_/  
       
       

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
AUDI S2 VEMS Motronic ECU plug'n'play 1.1.62 firmware COPS Emil found out that the '''trigger error (wheel error) and bad running was caused by a broken of tooth off of the 135 primtrig VR wheel'''. That's why the engine suddenly began to show wheel-err and run bad after 2.5 years of good operation. '''ignouts are nonstandard, 5 power-IGBT to drive renault COPs''' - a possible interference hazard by itself. * Wheel-error counts up continuously with 2 different ECUs (both behave well on bench) * We '''need to somehow cut ignition and see if wheel error continues counting'''. (overrun mode). Actually * Marcell scoped the crankhome-VR very precisely inside HALL window (only seen signal during cranking, no sparks) * the 135 was a bit admittedly noisier though. AND ONE TOOTH BROKEN OFF !!!! * The 1 cranktooth VR was changed to 5 tooth VR. 4 teeth were added (not stainless steel :-) ** the engine started with ECU pin47 and pin49 connected, but this (having both primary and sectrig pulse at same position) is not valid setup ** so inside the ECU the sectrig VR jumper was removed (the ECU is now sectrig=HALL). We left the camhall inverter setup inside the box (this just changes the trigger edge to be configured). There is something strange: * black 3pin female on firewall (ECU pin 47) seems to be inverted compared to factory (orig crankhome VR signal ?): Positive when moving hammer close (negative when moving away) * grey 3pin female on firewall (ECU pin 49) seems to be factory setup: negative when moving hammer close (positive when moving away). For VEMS the inverse polarity is needed ! --------------- 1.1.62 NoPS2Firmware 10+1 trigger. http://www.vems.hu/files/Fero/AudiS2/v3.3_n001941-2009.12.15-18.21.10._1.1.62_kocsiban_vemscfg.vemscfg http://www.vems.hu/files/Fero/AudiS2/v3.3_n001941-2009.12.15-18.22.00.zip
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.