_ _ ( ) ( ) `\`\_/'/' `\ /' | | (_)
/\ / \ / /\ \ / ____ \ /_/ \_\
## ## ##### ## ## ## ## #####
# # # # # ## ### # # ####
IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now. Visit Preferences to set your user name Summary of change: Engine came without harness, so using v3harness. Most parts are standard (trigger), but output is nonstandard: * MembersPage/FabioAudi/InputTrigger * MembersPage/FabioAudi/FuelDelivery (and idle solenoid) * MembersPage/FabioAudi/IgnitionOutputs '''ECU 1432''' * has '''camhall inverter inside''' (since 2008-07-20) * weak 2k7 pullup for '''NTC type MAT sensor''' ** when running Marcell's engine (with factory PTC, around 500 Ohm), MAT reading was 67C (but tested OK on bench) wbo2 parameters: * wbo2_pump_pw_zero=67 * wbo2_nernstdc_target=85 other: * egt1_cal=4c The config and tables used to run MembersPage/MarcellGal/PowerAndTraction * beware that Marcell's cam-HALL is 360 degrees rotated, ** and use different ignition outputs (cyl1 is from stepperD and factory power output stage, cyl2,5 and cyl3,4 are 2x2 wasted spark transformer) ** verify on MembersPage/FabioAudi/IgnitionOutputs that it matches yours * http://www.vems.hu/files/MembersPage/Fabio/Audi/FabioECUrunsMarcellsAudi.zip ** with the following Econoseal to motronic55 (3B) adapter: http://www.vems.hu/files/MembersPage/Fabio/Audi/ Optional: Add document to category: Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.