_ _ | \ | | | \| | | . ` | | |\ | |_| \_|
###### ## ## ## ## ## ## ## ## ## ## ## ## ## ## ##
### # # ## # ## ### # # #
### ## ### ## ## ## ## ## ### ## ## ## ###
### ## ## ## #### ## ## ####
IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now. Visit Preferences to set your user name Summary of change: '''Engine''' Inline 4 cylinder natually aspirated engine. '''Intake''' Stock setup is four 39mm flatslide carburetters. Planned setup is 38mm throttles from a Suzuki GSX-R 600, including the stock injectors. http://pusher.dk/zxr/images/efi2.jpg Note: This is from a GSX-R 1000, but the 600 version is very similar. '''Ignition''' Planning to use Suzuki GSX-R coil on plug. Currently the stock setup is CDI with two coils. Trigger wheel: http://pusher.dk/zxr/images/zxr_ignition.jpg Recent photo of the engine. Two wires run to the pickup coil. That would make it an VR type? '''VEMS''' Diagnose plug (rs232), Bulgin - Micro Buccaneer 400 Series. '''Sensors''' * TPS. According to the Haynes Suzuki Manual the TPS shold have a resistance of 1.1Kohm when closed and 4.3Kohm when open. * MAP * Crank trigger. Almost certain that stock can be used. Most likely VR. (HALL or even optical can be used as well, just find out which type it is: count wires, measure Ohm with DVM, etc..). * CLT * IAT * WBO2 '''Injectors''' According to the Haynes Suzuki Manual the injectors are supposed to have an resistance of 11-16 ohms @ 20C. [MembersPage/PhatBob] I think that we need to have some sort of priority list for the manual. Triggers: Types (Hall, VR, optical, distributor) and configuration (missing tooth, multi tooth, sync etc) Sensors: Water, air, tps, map (manifold fitting guide required) Injectors: High/LowZ ---- Apologies for posting this here, but we should discuss the changes to the manual if we are both to work on it together. Your changes look good, so I don't have trouble with that, it would just help to know what one is doing so the other doesn't change the same things. Meet up on IRC this weekend sometime? When is good for you? Im on IRC most of the time also this weekend. Would like to discuss where we are heading with the manual. I was under the impression that I was the only one working on it... Seems not - which is good :-) Optional: Add document to category: Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.