####   
     ##  
  #####  
 ##  ##  
  #####  
         

         
         
 ######  
  ##  ## 
  ##  ## 
  #####  
  ##     
 ####    

         
   ##    
         
  ###    
   ##    
   ##    
  ####   
         

  _   _ 
 | \ | |
 |  \| |
 | |\  |
 |_| \_|
        

  ___  
 / _ \ 
/ /_\ \
|  _  |
| | | |
\_| |_/
       
       

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Hi. Need some help on building an plugnplay-ecu for an old 10v urquattro running a 25pin toshiba ecu. Its running the standard three sensor Auditrigger. Ive connected the Primary VR sensor to EC36/27. Should I connect the Hallsensor to EC36/13? Where on the board should i connect the Secondary VR sensor? http://vems.hu/files/ErikEnglund/pictures/urquattro_board.jpg Board Serialnr 3919 . Ordered with Auditrigger setup. Thanks for all your help! Ive come this far: http://vems.hu/files/ErikEnglund/pictures/urquattro_pnp.jpg Connect the sec VR trigger like this black and red wires http://www.vems.hu/files/ErikEnglund/pictures/Auditrigger_sec.jpg You may need a 1.5 kohm resister mounted on solder side at ends of wires. (Pull down) http://www.vems.hu/files/ErikEnglund/pictures/Auditrigger_R.jpg
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.