##      
 ##      
 #####   
 ##  ##  
 ##  ##  
 ##  ##  
         

   ##    
   ##    
  #####  
   ##    
   ##    
   ## ## 
    ###  
         

  ____  
 / ___| 
 \___ \ 
  ___) |
 |____/ 
        

   ____  
  / __ \ 
 | |  | |
 | |  | |
 | |__| |
  \___\_\
         
         

 _   __
| | / /
| |/ / 
|    \ 
| |\  \
\_| \_/
       
       

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
I'm in need of support for the standard trigger on Nissan 350z * V6 Engine code [http://en.wikipedia.org/wiki/Nissan_VQ_engine|VQ35] ** even fire (every 120 crankdeg) like the VW VR6 engine ? ** or odd fire ( like 90,150,90,150,90,150 ) ? It has dual cam control (vanos-like) * 2 intake cams ? Will do some more research these upcoming days about the output requirements for the camshaft control. Attached is a picture of triggerpattern for this engine ( only '''crank and the two inlet sensors''', will look at how the exhaust sides looks like). Is it possible to get functioning? * it is possible to control 2 cams (like 2 intake) * controlling 4 cams would require 5 trigger inputs ** the maximum used so far was 4 trigger inputs (subaru boxer, 1 crank, 1 sectrig that is not moving, 2 camshaft-feedback measured) ** it is possible to gate (practically XOR) 4=>2 or even 4=>1 inputs to trigger inputs (and watch the other inputs via simple GPIO). Priority would be bumped up if there are a couple of installs in sight ( in any case very unlikely to be implemented before summer 2013). I guess theres only need for '''measuring one Inlet and one exhaust cam?''' * only if it has only 1 intake and 1 exhaust actuator, otherwise '''unfortunately NO !''' ** With most actuator-types '''feedback is required from EVERY controlled cam''' (because the actuator is "unstable" so control must continuously react independently for the 2 intakes). But if ---- 12-2 pattern every 120 degrees (normal tooth width = 10 crankdeg). http://vems.hu/files/ErikEnglund/pictures/Nissan-VQ35-VVT.jpg "Play trigger" signal-pattern implemented (for benchtests) in vemstune (> 2013-02-15) under name "m066". The sectrig with 36-2 primtrig seems to be fully supported (using secignore for sectrig, and measure_tooth settings for trigger), but with those 3 gaps it would need separate implementation * kinda like the ingenious MembersPage/YasecElise (== same as K-rover trigger, which has 4 gaps) ** but combined with sectrig-condition (not possibly just by looking at primtrig, because of the unfortunate 120 deg periodicity)
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.