_       
| \    /\
|  \  / /
|  (_/ / 
|   _ (  
|  ( \ \ 
|  /  \ \
|_/    \/
         

###      
 #####   
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
######   
         

         
         
 #    #  
 #    #  
 #    #  
 #   ##  
  ### #  
         

         
         
 ##  ##  
  ####   
   ##    
  ####   
 ##  ##  
         

         
         
 ##  ##  
 ##  ##  
 ##  ##  
  ####   
   ##    
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Boxnumber, 2274 This is an Motronic55-box for 3b engine. Im changing the trigger-input types to hall for both primary and secondary trigger. The jumpers and the resistor for primary trigger is already done(SJ2, SJ6, R30). Need help with the secondary trigger setup. We want to use the original wiring for secondary trigger (going to use the hall-sender in the distributor) Should something be done to the wire from motronic-pin 8 ? If so, where should the secondary trigger input be connected to the board? Or is it OK when changing the jumpers? *Answer: For secondary Hall you need just open SJ7. No matter what type of input you have - inverted or non-inverted - Hall signal will be active. Later just chose falling or rising accordantly in Vemstune. GintsK **Thanks GintsK! De-jumper SJ7: http://www.vems.hu/files/ErikEnglund/pictures/IMG_0013.jpg This board looks like this. http://www.vems.hu/files/ErikEnglund/pictures/IMG_0014.jpg So i dont realy know what to do with the information shown on this picture: http://www.vems.hu/manual/html/images/Testing/v3.6_sec_trigger_1_m.jpg http://www.vems.hu/files/ErikEnglund/pictures/IMG_0006.jpg Thanks in advance. /Erik
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.