#####   
 ##  ##  
 ##      
 ##      
 ##      
         

  _____
 |__  /
   / / 
  / /_ 
 /____|
       

  ______
 |___  /
    / / 
   / /  
  / /__ 
 /_____|
        
        

         
         
 ######  
  ##  ## 
  ##     
  ##     
 ####    
         

         
         
  ####   
 ##  ##  
 ######  
 ##      
  #####  
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
I have access to wiring diagrams for any vehicle available in North American 1983-present. Sometimes I can cross it over to Rest Of World cars. If you need schematics for anything, feel free to email me. alandaeric at hotmail dot com ---- From now, trying to organize thematically by splitting to subpages instead of an unstructured list of all the questions * MembersPage/EricN/Trigger - inputtrigger * MembersPage/EricN/Ignition - ignition advance, ignition output and coil related knowledge * MembersPage/EricN/Sensor - sensors * MembersPage/EricN/BuildNotes : list of steps to complete my install from the very start ---- SHOPPING LIST Have: Everything GenboardV3.2 1 x TPIC8101DW. Dual-channel acoustic knock sensor interface chip 1 x Stepper driver IC, package: DIP16 9 x FET: FQPF20N06L (FAI) 15A, ---- MY PROJECT Ford 347 stroker- on hold,(taking to long to build car) Temporarily putting it in a 61 404 unimog, mercedes 2.2l straight 6. *Standard Honda map sensor (maybe) *Standard Honda ect sensor *Standard Honda air temp sensor *Not sure which idle stepper motor, whatever the 1000cfm throttle body comes with (most likely 4-wire GM bipolar stepper) *Bosch WB 02 *knock sensor: not installed yet. Any should work that can be bolt on appropriately. Hit the block with a wrench and record sound with notebook soundcard to check it's operation *Trying to decide on input trigger *LS1 cnp coils about my_make or config.txt? config.txt contains all of your tables and running settings, and my_make contains settings regarding hardware (enabling LCD, keyboard, WBO2, etc). If you are looking to learn about config.txt, look into the file called global.h, or read through MembersPage/Jimw/Config A lot of settings are also described in the manual. Will this VFD work easily?? http://www.vfdworld.com/techdocs/Noritake_CU20045SCPB-T23A_4x20_VFD.pdf It's a serial VFD, it will not work. You need a paralell interface with a 44080 compatible command set. Note that VFD displays often have small incompatibilities with LCD displays even if they are listed as LCD compatible. ---- '''WISH LIST''' *I would like to have a configureable speedo output. (not for my project) *Drive by Wire, need some serious help with that one.
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.