__  __ 
 |  \/  |
 | |\/| |
 | |  | |
 |_|  |_|
         

______ 
|  ___|
| |_   
|  _|  
| |    
\_|    
       
       

         
         
 ### ##  
 #  #  # 
 #  #  # 
 #  #  # 
 #  #  # 
         

         
         
  ####   
 ##      
 ##      
 ##      
  ####   
         

  ###    
   ##    
   ##    
   ##    
   ##    
   ##    
  ####   
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
'''Trigger related page for MembersPage/EricN''' Started over with input trigger ideas. Took a VR sensor and 24 tooth trigger wheel out of a Honda Civic distributer. Ground off 1 tooth, pressed it on to a gutted Unimog distributer (took the whole advance mechanism out). Welded a plate inside, mounted the VR sensor on the plate. Now I have a 24-1 trigger wheel driven by the cam. http://www.vems.hu/files/EricN/inputtrigger.jpg ---- My plan is to run as a 12 cyl (engine is a 6) pretending to fire wasted spark so I can use the COP coils. I thought I read somewhere about setting the number of cycles that will trigger a reset (not sure if I worded it right but meant that engine sees the missing tooth 2 times then it starts over) Not too sure if setting that to 1 cycle would work somehow, need to try and find it again. * tooth_wheel=17 # (decimal 23 for 24-1 tooth wheel) * trigger_tooth=00 # (or 01, 03 or 03) * another_trigger_tooth=04 # (to fire 6 times every crankrot) * divider=01 * alternate=15 # 6 injector banks; fire all banks at cranking * ignchmax=05 h[0]=01 02 04 08 10 20 40 80 # change if wiring differently h[2]=01 03 04 06 07 08 05 05 # the last 2 entries not used with ignchmax=05. Note that channel 2 and 5 recommended as spares (not populated in the 6-driver version assembled unit). Curious why to use 2 and 5 for spares (already wired/setup/tested and working using channels 00-05, should I change it?)
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.