# ###   
 ##   #  
 #       
 #       
 #       
         

         
     ##  
         
     ##  
     ##  
     ##  
     ##  
  ####   

         
         
  ####   
     ##  
  #####  
 ##  ##  
  #####  
         

         
         
 #####   
 ##  ##  
 ##  ##  
 #####   
 ##      
 ##      

 _     _ 
( )   ( )
`\`\_/'/'
  `\ /'  
   | |   
   (_)   
         
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
'''Trigger related page for MembersPage/EricN''' '''truck is a 6 cyl. I am firing cop coils and using a distributer mounted trigger wheel. Tooth count 12-1''' Board is a v3.2 serial number=110 Trying an optical trigger now, followed instructions for Hall sensor on primary trigger as per manual. Seems to trigger properly. Picked up an OPB804 optical switch. Built it into this little circuit that I found on the internet http://www.vems.hu/files/EricN/opticaltrigger.JPG Changed the 1k resister to 100ohm, voltage at led is 1.25v to gnd (normal for an infrared LED). Using pullup on vems signal high (beam blocked) is 4.6V (good, since it goes higher than 2V) low is .25V to gnd (good, since it goes under 0.6V) MembersPage/EricN/Trigger/Optical MembersPage/EricN/Trigger/Problem
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.