##   ## 
 ## # ## 
 ####### 
  #####  
  ## ##  
         

###      
 #####   
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
#### ### 
         

         
         
 #####   
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
         

 ##      
 ##      
 #####   
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
         

         
  #####  
 ##  ##  
 ##      
 ##      
 ##   #  
  ####   
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
This is my collection of links that I have found helpfull and ones I have found and am not sure how to find again. As well it is also my buid diary so I know what to do next time. DONE LIST # Soldered connector to board. # Make [http://www.vems.hu/wiki/index.php?page=GenBoard%2FManual%2FCommHardware Serial Cable] and connect it to your PC and Connect the other end to your board. # Power the board. Out of fear, holding everything in my hand to feel if anything getting hot ** at (with 1A fuse) EC36 pin 25 (+8..14V) ** and (-) EC36 pin26, EC36pin5 (EC36pin21, EC36pin32). Be certain to connect at least one GND5 too. While this is not strictly necessary if no load is driven from the power-GND5 plane, we better condition everyone to always have as many GND5 connected as possible (3..4 in a production install) # Download and open Bray terminal. Use [http://vems.hu/www.vems.co.uk/VEMS/PowerUpTest.html this link] and follow his instructions. If it works, good, if not, make sure you used a capital M in Man and com port is correct as well as your cable is built correctly. # Download the [http://www.vems.hu/files/Firmware/release/ firmware] make sure it is the latest release. # Downloaded and installed [http://sourceforge.net/projects/winavr winavr] so you can have programmers notepad, only need it to enable wb 02 in my make, (I dont know of another way) more on that later. # Downloaded and installed avr studio 4, cant find the link now.
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.