_____ 
  / ____|
 | (___  
  \___ \ 
  ____) |
 |_____/ 
         
         

  ____  
 | __ ) 
 |  _ \ 
 | |_) |
 |____/ 
        

         
         
 ##  ##  
 ##  ##  
 ##  ##  
  #####  
     ##  
 #####   

 _   _ 
| \ | |
|  \| |
| . ` |
| |\  |
\_| \_/
       
       

  ____  
 |  _ \ 
 | | | |
 | |_| |
 |____/ 
        

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
'''Trigger setup''' for Audi S4, 5cyl Direct Fire engine * Primary trigger is VR 60-2 multitooth * Secondary trigger is a hall sensor, 10-20 Deg Slot fully adjustable (mockup distributor) * What is the best way to configure this ? ** firmware modification, done in 1.0.24 (ready for testing) * If we set another_trigger_tooth to 12 (5 per crankrot), and extend the h[2] table to 10 cells, and set dummy values every second cell, also for injectors, divider=02. I guess it would work? ** it would work, but with current stable firmware dwell-time would be limited at high RPM. In short, not a good solution. * Config http://linkopingsmotorsport.se/config.txt ** make sure you publish '''actual config''' (output of mcd) also, not just the intended config. If you mess up global.h (eg. using an old version, forget to update config.mtt file, whatever) this reveals the truth. * Tables http://linkopingsmotorsport.se/tables.txt * Datalog: http://linkopingsmotorsport.se/datalog200511141121.xls ** almost certain that this was captured with primary_trigger=coil-type config , which results in 24x higher RPM than actual. Even the missing tooth (1/3 RPM) can be seen ! Chance is very high that this was not taken with above config in the controller. '''bad values''' * another_trigger_tooth=0C (should be 0x18 = decimal 24) * crank_minper=A9 (should be lower, like 0x50 or decimal 80) * ign_crank_advance=00 (I guess it will be adjusted later)
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.