##    
         
  ###    
   ##    
   ##    
  ####   
         

 _   _ 
( ) ( )
| | | |
| | | |
| \_/ |
`\___/'
       
       

  ###    
   ##    
   ##    
   ##    
   ##    
   ##    
  ####   
         

  _____  
 |  __ \ 
 | |  | |
 | |  | |
 | |__| |
 |_____/ 
         
         

         
         
 ##  ##  
 ######  
 ######  
 ##  ##  
 ##  ##  
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
'''Trigger setup''' for Audi S4, 5cyl Direct Fire engine * Primary trigger is VR 60-2 multitooth * Secondary trigger is a hall sensor, 10-20 Deg Slot fully adjustable (mockup distributor) * What is the best way to configure this ? ** firmware modification, done in 1.0.24 (ready for testing) * If we set another_trigger_tooth to 12 (5 per crankrot), and extend the h[2] table to 10 cells, and set dummy values every second cell, also for injectors, divider=02. I guess it would work? ** it would work, but with current stable firmware dwell-time would be limited at high RPM. In short, not a good solution. Config http://linkopingsmotorsport.se/config.txt Tables http://linkopingsmotorsport.se/tables.txt Datalog: http://linkopingsmotorsport.se/datalog200511141121.xls '''bad values''' * another_trigger_tooth=0C (should be 0x18 = decimal 24) * crank_minper=A9 (should be lower, like 0x50 or decimal 80) * ign_crank_advance=00 (I guess it will be adjusted later)
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.