__   __
\ \ / /
 \ V / 
 /   \ 
/ /^\ \
\/   \/
       
       

 __          __
 \ \        / /
  \ \  /\  / / 
   \ \/  \/ /  
    \  /\  /   
     \/  \/    
               
               

         
         
  #####  
 ##  ##  
 ##  ##  
  #####  
     ##  
 #####   

         
         
 ##  ##  
 ######  
 ######  
 ##  ##  
 ##  ##  
         

         
         
  #####  
 ##  ##  
 ##  ##  
  #####  
     ##  
 #####   

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
'''Trigger setup''' for Audi S4, 5cyl Direct Fire engine '''Audi 2,2T AAN engine''' Now with orginal trigger ECM: 3.3 #332 Modified to accept auditrigger *added lm1815 *added 100k resistor at R182 *added wire, ec18pin12 to R90 **measure at lm1815 pin3 that this signal comes through (with scope) *added blob at SJ7 ** also scope here to see the signal mix from distributor and sec lm1815 output. also try to take a log with distributor unplugged, you should see 0x0A for each secondary trigger All sensors original except for map/iat: Bosch 0 281 002 437 Firmware 1.0.29 00:21 Config http://linkopingsmotorsport.se/1029/config.txt Tables http://linkopingsmotorsport.se/1029/tables.txt ---- OldPage with 60-2 + camsync. Had runout and very little space to fix triggerwheel ---- '''See also''' * MembersPage/EmilMalmsten
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.