##  ##  
 ##  ##  
 ######  
 ######  
 ##  ##  
         

         
         
 #####   
 ##  ##  
 ##  ##  
 #####   
 ##      
 ##      

         
         
 #####   
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
         

         
         
 ##  ##  
 ####### 
 ####### 
 ## # ## 
 ##   ## 
         

   _____ 
  / ____|
 | |  __ 
 | | |_ |
 | |__| |
  \_____|
         
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Problematic car with strange ignition problem Trigger is 24 on crank, 1 on cam (48+1), c048.wav applies. Trigger log (with 1.1.77) says all entrys besides first is ratio 1.0 first problem was too low cranking rpm (~120 rpm), that is fixed, now cranking at 190 rpm with plugs installed, at this moment all plugs are out and strobe light are installed, 3 out of 4 outputs in h[2] is flashing simultaneously, one is not flashing at all config file: http://media.vems.se/vemscfg/LS1_notworking.vemscfg the config file here has h[2] reset to 00 because crap was injected in my saved file, config is tested with stepper out (h2=38 68 58 48 38 68 58 48 iirc) c048 works with auditrigger divby3 (reduced to 16 teeth, another_triggertooth=2, tooth width=45 degrees): [http://www.vems.hu/files/MembersPage/EmilLarsson/LS1/v3.3_n001212-2010.06.08c048workswithdivby3.vemscfg this vemscfg] was not started from the above. When I started from above LS1_notworking.vemscfg, I got sparkangle jumping (cause not yet identified). With auditrigger, it is allowed that secondarytrigger sometimes comes 1 primarytrigger tooth late. (if the tooth-position ever changes, it's actually good for sectrig to hit the earlier tooth in all sessions, and tune to that). With standard coil type the sectrig "racing" with primtrig (changing relative position) is not allowed. Since with a 15 degree gap it is very difficult to get the sectrig pulse (chosen edge) right in the middle of 2 primtrig tooth (+-7.5 degrees away), and make sure it is always between the same teeth with the camdrive sloppyness, the auditrigger setup seems more appropriate. --- '''Engine is now running''' Corruption in config had sneaked in, vemstune didn't catch that ignchmax=77 when it was supposed to be 07 (drop down in VT still showed correct) the LS1 makes a nice noise with a single 75 mm turbo!
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.