_       _ 
( )  _  ( )
| | ( ) | |
| | | | | |
| (_/ \_) |
`\___x___/'
           
           

   ###   
  ## ##  
  ##     
 ####    
  ##     
  ##     
 ####    
         

         
|\     /|
| )   ( |
| |   | |
| |   | |
| |   | |
| (___) |
(_______)
         

         
   ##    
 ######  
   ##    
   ##    
   ##    
    ###  
         

         
         
 ##  ##  
 ##  ##  
 ##  ##  
  ####   
   ##    
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
This is my toy project, aiming for 200 hp from this 1.3L engine specs * 1301cc engine ** 80.5mm bore and 63.5mm stroke * approx 400 cc/min opel/vauxhall injectors * T3 turbo from a volvo 740 turbo ** [http://kombi.ulkhyvlers.net/garage/s-turbos2.jpg picture], from the right is stock fiat RB5, followed by the T3, and the Garrett GT40 that will be installed in the volvo * OMP sintered ceramic clutch disc with reinforced cover * I [http://kombi.ulkhyvlers.net/garage/s-IMGP1182.JPG uninstalled] some unneccessary parts from the engine bay and behind dashboard, will be replaced with better stuff * Of course will it be equipped with a Vems Genboard V3 unit for engine control, including WBO2, Advanced Antilag system, EGT and more More about the VEMS install issues: * Water temp sensor ** seems to be in a usable range, maybe just replacing the bias resistor * Air temp sensor ** Will use a simple webshop NTC resistor (approx 1 euro) * Throttle Position Sensor ** Has to be replaced, maybe with volvo 850, or ford sensor * MAP sensor ** a 400 kpa sensor will be installed inside the unit * Trigger ** Here it gets a bit tricky, there are 2 trigger wheels on the engine: *** crank pulley: 2 teeth, placed very close to TDC (adjustable a few degrees to any direction) *** Flywheel: 4 slots milled into the flywheel, 2 at TDC and 2 at 90 deg BTDC ** '''Q:''' can this be hacked up to work using the auditrigger codebase or something? As both of the triggers are very hard to modify with my knowledge and tools.
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.