_      
 | |     
 | |     
 | |     
 | |____ 
 |______|
         
         

         
         
  ### #  
 #   ##  
 #   ##  
  ### #  
      #  
      #  

         
 ##      
 ##      
 ## ##   
 ####    
 ## ##   
 ##  ##  
         

______ 
| ___ \
| |_/ /
|  __/ 
| |    
\_|    
       
       

  _____  
 |  __ \ 
 | |  | |
 | |  | |
 | |__| |
 |_____/ 
         
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Got a good deal on a volvo 740 turbo, ---- '''current modifications''' Only a larger intercooler from a 850R estimated power 220-240 hp ---- TODO: Get a stock ECU that fits the connector, and kill it to make an adapter harness Trigger is a auditrigger-style, counting the starter gear and a crankhome pin. No hall sensor This seems to be supported by InputTrigger/AudiTrigger configuration, with changed another_trigger_tooth (but same tooth_wheel settings) * '''Four cylinder''' engine ** fire order : 1342 (I assume) * 142 teeth on the starter gear ** which means the processor sees 284=4*71 primary trigger pulses for each secondary trigger pulse ** '''another_trigger_tooth=47''' (decimal 71). this is the big difference compared to the 135 tooth auditrigger config ** '''tooth_wheel=87''' (decimal 135). one would think that tooth_wheel=8e (decimal 142) is right, but this variable is only used to activate the auditrigger-style trigger processing. So use the same as for auditrigger *crankhome signal 62 dbtdc cyl '''1''' ('''?''') * write about the cam-HALL polarity. Might require some measurements, ** since some HALL sensors pull down their outputs to GND when they see ferromagnetic metal in the shutter => higher magnetism (such as B field > 6 milliTesla). This is common for unipolar sensors. ** other HALL sensors (such as the factory audi HALL that goes with the 135-tooth engine) pulls down the output when it sees air ---- '''Ignition outputs and settings''' wasted spark or 4 COP coils ? If wasted spark, the ignition does NOT require to mask out every 2nd crankhome VR with the cam-HALL. * rethink the ** trigger_tooth (I expect that this will be decimal 69 = 0x45 or so, 1 tooth after the crankhome pulse detected - yes, unlike the normall missing tooth setup, for auditrigger the tooth counter counts down for efficiency) ** ign_tdcdelay=78 (decimal 120, that is 60 degrees; slightly lower will work too...). Because the cyl number is even, this is regardless if the crankhome signal is seen 62btdc cyl1 or 62btdc cyl4. ** and h[2]=... no surprise here. Just work out if crankhome-VR is seen 62btdc cyl1 or cyl4 to match the setup this engine.
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.