##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
  #####  
         

         
         
  ####   
 ##  ##  
 ##  ##  
 ##  ##  
  ####   
         

 _ 
(_)
| |
| |
| |
(_)
   
   

   ____  
  / __ \ 
 | |  | |
 | |  | |
 | |__| |
  \___\_\
         
         

 _____ 
(  _  )
| ( ) |
| | | |
| (('\|
(___\_)
       
       

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Preparations before install ---- * Make sure you have a working TPS (resistive type, not microswitch) * If you have a trigger wheel on your engine from factory, describe it and see if it's usable, otherwise, make a simple wheel on the front pulley and use a Honeywell GT1 sensor * Make a good ground point close to where your VEMS unit will sit * Check over mechanics once again, Oil, water, fuel system ---- While doing the install ---- ---- * Wire up temp sensors, check that readings are ok * Check that TPS is ok and calibrate, must react as soon as you start pressing the pedal * Wire up trigger, crank the engine and see that you have RPM signal * Wire up fuel pump, make sure it works properly * Wire up ignition coils, use a strobe light to check that tdc_delay is correct while cranking * Wire up injectors, start the car, and once again, use strobelight to see that advance is correct throughout the whole rpm range * C
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.