######  
    ##   
   ##    
  ##     
 ######  
         

         
 ##      
 ##      
 #####   
 ##  ##  
 ##  ##  
 ##  ##  
         

 _   _ 
( ) ( )
| | | |
| | | |
| (_) |
(_____)
       
       

 ______  
(  ___ \ 
| (   ) )
| (__/ / 
|  __ (  
| (  \ \ 
| )___) )
|/ \___/ 
         

  _   _ 
 | | | |
 | | | |
 | |_| |
  \___/ 
        

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
Vehicle Overview: 1989 BMW e30 with a M50b25 NV out of a 91 BMW 525 specs on VEMS: 1 x Assembled v3.6 controller - 1-wire interface: no - withSDcard: removable - PS2 connection: no - secondary_trigger: HALL Need to convert to VR! - mounting-style: no-screws - MAP connection: 400kPa (5/3mm pneumatic) - LCD connection: no - EGT input: 1 - Flyback: 30V flyback - ignition driver: 8 - Knock input channels: 2 - primary_trigger: EC36/27 VR VEMS was purchased for a later M50 with Hall. This engine has a VR/VR trigger setup. to extend coil life and prevent IGBT's from over heating a cam sync will need to be installed. After following directions on this page: http://www.vems.hu/wiki/index.php?page=GenBoard%2FManual%2FInputTriggerHardWare this is where the project sits. http://i1131.photobucket.com/albums/m548/southwestbimmers/Snapbucket/7A03402C-1-1.jpg http://i1131.photobucket.com/albums/m548/southwestbimmers/Snapbucket/IMG_0013.jpg
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.