##### ## ## ## ## ## ## ## ##
_ _ | | | | | | | | | |/\| | \ /\ / \/ \/
## ## ## ## ###### ###### ## ##
##### ## ## ## ## ##
_____ / __ \ | / \/ | | | \__/\ \____/
IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now. Visit Preferences to set your user name Summary of change: '''Testing the Sensors''' I've bench tested the NTC sensors and they work in pots of water at varying temperatures. I need to add a IAT sensor to the manifold somewhere. Found one in a scrappy for £1. It works nicely. The wiring is all in now, except for the wideband lambda sensors. I need to do some work on the exhaust before these will work. I have recompiled the firmware for the non-GM CLT & IAT sensors. Need to refine the calibration more as it isn't quite right. TPS just worked, which was nice. I can cope with this happening... '''Wideband Lambdas''' I'm fitting 2 of these - one for each bank. (I understand I need to modify the firmware for the 2nd to be supported.) I've just looked at the manual for wiring them up. '''Q'''': Should the cal resistor in the wideband sensor be connected to anything? It isn't in the diagram (it's on pin 2, and this appears N/C) '''A''': True the calibration resistor is not used in our wideband controller implementation, calibration is done trough adjustment of the calibration constant until your free-air o2% matches 20.95% Back to: MembersPage/DavidBlades Optional: Add document to category: Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.