####   
 ##  ##  
 ######  
 ##      
  ####   
         

         
|\     /|
| )   ( |
| | _ | |
| |( )| |
| || || |
| () () |
(_______)
         

         
         
 #####   
 ##  ##  
 ##  ##  
 ##  ##  
 ##  ##  
         

_________
\__   __/
   ) (   
   | |   
   | |   
   | |   
   | |   
   )_(   
         

         
         
 ##  ##  
 ##  ##  
 ######  
 ######  
 ##  ##  
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
'''Testing the Sensors''' I've bench tested the NTC sensors and they work in pots of water at varying temperatures. I need to add a IAT sensor to the manifold somewhere. Found one in a scrappy for £1. It works nicely. The wiring is all in now, except for the wideband lambda sensors. I need to do some work on the exhaust before these will work. I have recompiled the firmware for the non-GM CLT & IAT sensors. Need to refine the calibration more as it isn't quite right. TPS just worked, which was nice. I can cope with this happening... '''Wideband Lambdas I'm fitting 2 of these - one for each bank. (I understand I need to modify the firmware for the 2nd to be supported.) I've just looked at the manual for wiring them up. Should the cal resistor in the wideband sensor be connected to anything? It isn't in the diagram (it's on pin 2, and this appears N/C) Back to: MembersPage/DavidBlades
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.