###    
     #   
  ####   
 #   #   
  ### #  
         

   ##    
         
  ###    
   ##    
   ##    
   ##    
  ####   
         

 _____ 
|_   _|
  | |  
  | |  
 _| |_ 
 \___/ 
       
       

 ###     
  ##     
  ##     
  #####  
  ##  ## 
  ##  ## 
 ######  
         

         
 ##      
 ##      
 #####   
 ##  ##  
 ##  ##  
 ##  ##  
         

IMPORTANT: enter the case-INsensitive alphabetic (no numbers) code AND WRITE SOME SHORT summary of changes (below) if you are saving changes. (not required for previewing changes). Wiki-spamming is not tolerated, will be removed, so it does NOT even show up in history. Spammers go away now.


Visit Preferences to set your user name
Summary of change:
The car is now running, but i fould a fault in the firmware/software! When you use the overrun fuel cut mode it completly ignores the Fuel resume rpm. In the attaced config and logfile i have set the fuel resume rpm to 2200 rpm, but the car holds the fuel cut until about 850 rpm. The presure control is working ok, but the rpm isnt.. '''Answer:''' You are activating fuelcut below kpa, and never activated fuelcut rpm, to exit fuelcut from kpa, you need to reach setting (22) + 4 kpa to reenable fuel //Emil Configfile: http://www.vems.hu/files/Racezone/Supercharged/no%20fuelcut%20resume..%20.vemscfg Logfile: http://www.vems.hu/files/Racezone/Supercharged/Fault%20no%20fuel%20cut,%20why.vemslog Any ideas ? Regards Daniel Hello, i am installing vems on a supercharged toyota ae92gti! I am using the OEM VR Sensors. *The car is now running. They installed firm. 1.1.96 and typed 24 in menu sectrigger “Maximum primary edge between secondary edges”. Nice function Log will come later. /Peter http://www.vems.hu/files/Racezone/Supercharged/2012-03-19%202022.jpg There are 3 sensors in the " dizzy" One there are counting the 24 tooth in the bottom. ( primary trigger) Two sensors triggering at the wird 1 tooth wheel. There are placed 180degrees. I am useing the one sensor so it triggers one tooth in 720 crank degress. I have some troubles about the sec trigger, i got the Sec trig pos bad offen.. I have tryed everything ( allmost ) Triggering on diffrent edges and so on. Can any one look at my settings, and trigger logs ? http://www.vems.hu/files/Racezone/Supercharged/2012-03-23%2020.19.50.jpg http://www.vems.hu/files/Racezone/Supercharged/Starting.vemscfg http://www.vems.hu/files/Racezone/Supercharged/v3.3_u004134-2012-03-22-21.31.15.triggerlog http://www.vems.hu/files/Racezone/Supercharged/v3.3_u004134-2012.03.24-21.52.58.vemslog I have briged R182, 5V modeselect, 1k ohm pull down, but it isnt real good.. Any surgestions ? Trigger is of cause 24 + 1 Thanks Daniel
Optional: Add document to category:
Wiki formatting: * is Bullet list ** Bullet list subentry ... '''Bold''', ---- is horizontal ruler, <code> preformatted text... </code> See wiki editing HELP for tables and other formatting tips and tricks.